Skip to main content
Lakeway, TX · 2 ZIP codes

Full-System Air Duct Cleaning in Lakeway

Whole-home source-removal cleaning of every supply and return run.

01Lakeway — the housing record

What Lakeway actually has behind its walls.

Before anyone quotes a duct job here, this is the stock they are quoting against. It is public Census data, and it is different in every city we cover.

Lakeway — housing recordACS 2023
Housing units
8,875
Built pre-1980
3%
Built 2000s
36%
Built since 2010
35%
Gas heat
26%
Electric heat
63%
Single-family
80%

U.S. Census Bureau, American Community Survey 5-Year Estimates (2023), tables B25034, B25040 and B25024. Percentages are rounded and describe the city, not your house.

What that means for ducts

New-build ductwork

Roughly 35% of Lakeway's homes were built since 2010. New does not mean clean: the commonest thing we pull out of a five-year-old system is the construction phase itself — drywall fines, sawdust, insulation fiber — plus builder-grade flex that was kinked or crushed on the day and has been throttling that run ever since. Photographs matter more here, not less.

That is a reading of the city’s stock, not a diagnosis of your home. Which of it applies to you is exactly what the camera settles — and why we would rather run one than quote from a postcode.

02Working in Lakeway

The part that changes from street to street.

Lakeway houses are large and they are cut into a hillside, and both facts show up in the mechanical layout rather than in the age of the duct. Most homes here are recent enough that nothing has accumulated from decades of use. What they have instead is two or three separate systems, split by floor or by wing and often tied to zone dampers and a control board, and that changes what an honest quote even looks like. A single price to clean a house means very little on this side of the lake. The number that matters is per system, and in many of these homes only one of them is doing real work. The upper zone runs hard all summer while a lower level built into the slope stays cool, so its system barely cycles, never dehumidifies, and grows things on a coil that is wet more often than it is used. Heat is electric in most of the city, so we are looking at coils and drain pans instead of burners and flues.

Lakeway Marina

Where in Lakeway2 ZIPs
  • Rough Hollow ·
  • Flintrock Falls ·
  • The Hills ·
  • Lakeway Highlands

County

Travis County

(469) 287-0686
The method does not change by city

Same standard in Lakeway as everywhere else.

Source removal to the NADCA ACR standard, a written quote before anything is touched, and camera photographs of your own runs before and after. We are not going to re-argue that on every city page — it is set out once, in full, on the service page.

  • Every supply and return run agitated and vacuumed under negative pressure
  • Supply and return plenums cleaned at the air handler
  • All registers and grilles removed, washed, and re-seated
  • Before-and-after camera photos of your actual ductwork
From
$349
On site
3–5 hours
Scope
4 lines
The full method

Prices shown are starting estimates and may change with the condition, access, and scope we find on site. Only a written quote from an on-site visit is a price we commit to.

03Full-System Air Duct Cleaning — in this stock

Cleaning a system that is still carrying its own build.

A post-2010 system is usually not dirty in the way people picture. What comes out is the construction phase — drywall fines, sawdust, insulation fiber — that was pulled into open ducts before the house was ever occupied, plus whatever a kinked flex run has been collecting behind the crimp. That is a different cleaning: shorter, more targeted, and far more dependent on the before-and-after photographs, because the difference is not something you can smell.

Full-System Air Duct Cleaning on one of our own jobs
Asked about full-system air duct cleaning
  • Do I need to leave the house during the cleaning?

    No. The system is sealed and under negative pressure while we work, so dislodged debris travels into the HEPA collector, not your rooms.

  • Can the tools damage my ductwork?

    Tooling is matched to the duct: rotary brushes for sheet metal, gentler air whips for flex. The pre-clean camera pass documents existing damage first, so nothing gets misattributed.

All full-system air duct cleaning questions

04Book in Lakeway

Three fields, and a person calls you back.

Tell us the ZIP and we will tell you what your system likely needs — including, sometimes, that it needs nothing yet. Nothing is charged until you have approved a written quote.

Full-System Air Duct Cleaning — Lakeway

3 fields

We cover all 2 Lakeway ZIP codes. Leave three fields and we will confirm a window by phone.

Rather talk now? (469) 287-0686

05Questions

Asked in Lakeway, answered straight.

Do I need to leave the house during the cleaning?

No. The system is sealed and under negative pressure while we work, so dislodged debris travels into the HEPA collector, not your rooms. The HVAC itself is off for the duration — three to five hours — which in summer is the only real inconvenience. Most customers simply work around us.

Can the tools damage my ductwork?

Tooling is matched to the duct: rotary brushes for sheet metal, gentler air whips for flex. The pre-clean camera pass documents existing damage first, so nothing gets misattributed. If a run is too fragile to clean safely, we photograph it, tell you plainly, and leave it alone.

Why do you quote per system instead of per house?

Because a house here can hold three of them and their condition is rarely the same. Quoting by the address either overcharges you for systems that are already clean or quietly leaves one out. We scope each unit, tell you which ones need work, and price only those. Two clean systems and one that needs attention is a common outcome in this city.

The lower level smells musty and it is the coolest part of the house.

That combination is common on these hillside plans and it is a runtime problem rather than a dirt problem. A system serving a level built into the slope satisfies the thermostat in minutes and shuts off, so it never runs long enough to remove moisture. Cleaning the duct will not change the humidity. Dehumidification, or a change in how that zone is controlled, will.

We have zone dampers. Do they matter for this?

Enough that we check them before anything else. A damper stuck part closed, or a bypass duct dumping supply straight back into the return, reads from inside the house exactly like a blocked branch. It is worth knowing that a control board is the cause before paying someone to brush a duct that was never obstructed in the first place.