Skip to main content
Service area · 2 ZIP codes

Air duct work in Leon Valley, TX

Most of Leon Valley was framed in the 1980s and 90s, and in that period around San Antonio the supply plenum and often the main trunk were built from fiberglass duct board rather than sheet metal. That one construction decision governs what can honestly be done in these houses.

01Where to start in Leon Valley

Not every city needs the same thing first.

Mixed-era stock is where guessing from the curb goes wrong most often — two houses on the same street can need completely different work, so the camera comes first.

  1. Camera Duct Inspection & Air-Quality Assessment
    01$99

    Camera Duct Inspection & Air-Quality Assessment

    See inside your ducts before you spend a dollar on cleaning.

  2. Full-System Air Duct Cleaning
    02$349

    Full-System Air Duct Cleaning

    Whole-home source-removal cleaning of every supply and return run.

  3. Filtration Upgrade Consultation
    03$99

    Filtration Upgrade Consultation

    The right MERV rating for your system — no guesswork, no overkill.

An ordering suggested by the city’s housing record below — not a diagnosis of your home. Prices shown are starting estimates and may change with the condition, access, and scope we find on site. Only a written quote from an on-site visit is a price we commit to.

02The record

Leon Valley by the numbers that actually change the work.

Leon Valley — housing recordACS 2023
Housing units
5,039
Built pre-1980
17%
Built 2000s
17%
Built since 2010
8%
Gas heat
33%
Electric heat
63%
Single-family
55%

U.S. Census Bureau, American Community Survey 5-Year Estimates (2023), tables B25034, B25040 and B25024. Percentages are rounded and describe the city, not your house.

What that means for ducts

Mixed-era stock

Leon Valley splits across build eras — 17% pre-1980, 8% since 2010 — so two houses on the same street can need completely different work. It is the case where guessing from the curb is worst, and where a camera before a quote saves the most money.

That is a reading of the city’s stock, not a diagnosis of your home. Which of it applies to you is exactly what the camera settles — and why we would rather run one than quote from a postcode.

On the ground in Leon Valley

Most of Leon Valley was framed in the 1980s and 90s, and in that period around San Antonio the supply plenum and often the main trunk were built from fiberglass duct board rather than sheet metal. That one construction decision governs what can honestly be done in these houses. Duct board presents a fibrous surface to the airstream, and a rotary brush does not clean it, it erodes it and sends the fibers downstream into your rooms. So on a system of that vintage we use contact vacuuming and gentle air tooling, and where the liner is already delaminating or has ever been wet, that section has to come out and be rebuilt by an HVAC contractor, which is not work we can sell you. Water is the other local reality. Creek flooding has been inside ground-floor rooms in this city within living memory, and duct board that has been submerged never dries in a way that matters, because silt stays in the fibers and the smell comes back every humid month for the rest of its life. Something close to half the housing here is not a detached house, and in those buildings the same duct board plenums sit in equipment closets serving units that change hands every year or two.

Neighborhoods2 ZIPs
  • El Verde ·
  • Forest Oaks ·
  • Bel-Lindo ·
  • Seneca

County

Bexar County

04Book in Leon Valley

We cover all 2 Leon Valley ZIP codes.

Leave three fields and a person calls back. Nothing is charged until you have approved a written quote — and if the camera says your system is fine, that is what we will tell you.

Leon Valley, TX

3 fields

Tell us the ZIP and we will tell you what your system likely needs — including, sometimes, that it needs nothing yet.

Rather talk now? (469) 287-0686

05Questions

Asked in Leon Valley.

How do I tell whether our plenum is duct board or metal?

Look at the box directly above or beside the indoor unit. Duct board is rigid but not metallic, roughly an inch thick, faced in foil with taped seams, and it sounds dull rather than tinny when you tap it. It was standard here through the 80s and 90s. It is not a defect by itself, but it does change the tooling we bring and it rules out aggressive brushing entirely.

Our ground floor took water years ago and there is a smell every summer. Can cleaning fix it?

If the wet material was duct board, no, and we would rather lose the job than pretend otherwise. Fibrous liner holds silt and biological material deep in the material where no tool reaches, and warm humid weather brings the odor back annually. That plenum or trunk section needs replacing. We document it with photographs so the HVAC quote you get afterward is based on evidence.

Our unit is in a stacked building and we control only what sits inside our own walls. What is worth doing?

The equipment closet, the filter arrangement and the return seal, all of which sit inside your walls. The building owns anything shared. In these 80s and 90s buildings the plenum is usually the dirtiest surface in the system and cleaning it alone is a legitimate partial job rather than an upsell, provided the liner is sound enough to take it.