Skip to main content
Service area · 5 ZIP codes

Air duct work in Spring, TX

Spring filled in between 1980 and the end of the 1990s, and that one build window sets the agenda for almost every job here. The systems we open are on their original flex duct, run through vented attics that sit brutally hot from May through September and stay humid the rest of the year.

01Where to start in Spring

Not every city needs the same thing first.

Mixed-era stock is where guessing from the curb goes wrong most often — two houses on the same street can need completely different work, so the camera comes first.

  1. Camera Duct Inspection & Air-Quality Assessment
    01$99

    Camera Duct Inspection & Air-Quality Assessment

    See inside your ducts before you spend a dollar on cleaning.

  2. Full-System Air Duct Cleaning
    02$349

    Full-System Air Duct Cleaning

    Whole-home source-removal cleaning of every supply and return run.

  3. Filtration Upgrade Consultation
    03$99

    Filtration Upgrade Consultation

    The right MERV rating for your system — no guesswork, no overkill.

An ordering suggested by the city’s housing record below — not a diagnosis of your home. Prices shown are starting estimates and may change with the condition, access, and scope we find on site. Only a written quote from an on-site visit is a price we commit to.

02The record

Spring by the numbers that actually change the work.

Spring — housing recordACS 2023
Housing units
22,974
Built pre-1980
1%
Built 2000s
33%
Built since 2010
17%
Gas heat
50%
Electric heat
47%
Single-family
86%

U.S. Census Bureau, American Community Survey 5-Year Estimates (2023), tables B25034, B25040 and B25024. Percentages are rounded and describe the city, not your house.

What that means for ducts

Mixed-era stock

Spring splits across build eras — 1% pre-1980, 17% since 2010 — so two houses on the same street can need completely different work. It is the case where guessing from the curb is worst, and where a camera before a quote saves the most money.

That is a reading of the city’s stock, not a diagnosis of your home. Which of it applies to you is exactly what the camera settles — and why we would rather run one than quote from a postcode.

On the ground in Spring

Spring filled in between 1980 and the end of the 1990s, and that one build window sets the agenda for almost every job here. The systems we open are on their original flex duct, run through vented attics that sit brutally hot from May through September and stay humid the rest of the year. Flex of that vintage has its insulation compressed flat at every strap and a belly sagging low between supports, and a sagging belly holds whatever gets past the filter. Fuel runs close to even across these subdivisions, so half the houses have a gas furnace above the ceiling and half have an air handler and heat pump, and those are not the same inspection. The other Spring pattern is the equipment platform itself. An attic air handler sits in a secondary pan that has not been touched since the house was finished, and when the primary drain slimes shut the first sign is a stain on a bedroom ceiling, not a change in the air.

Neighborhoods5 ZIPs
  • Gleannloch Farms ·
  • Klein ·
  • Old Town Spring ·
  • Augusta Pines

County

Harris County

04Book in Spring

We cover all 5 Spring ZIP codes.

Leave three fields and a person calls back. Nothing is charged until you have approved a written quote — and if the camera says your system is fine, that is what we will tell you.

Spring, TX

3 fields

Tell us the ZIP and we will tell you what your system likely needs — including, sometimes, that it needs nothing yet.

Rather talk now? (469) 287-0686

05Questions

Asked in Spring.

Our hall ceiling has stained in a circle, right where the attic unit sits above it. Ducts?

Almost never. In Spring's attic-mounted systems that ring is the condensate side: a primary drain line that has closed up and a secondary pan that finally caught the overflow. We check the trap, the pan and the float switch before discussing duct at all, because a system that has been wetting attic insulation is a repair conversation rather than a cleaning one.

Our hallway return is a big grille with a fiber-lined box behind it. Can that be cleaned?

Sometimes, and sometimes not, and it is worth knowing which before you pay. Site-built return plenums of that era are lined with duct board, and once the liner has gone soft in a humid attic it sheds fibers straight into the blower. A degraded liner cannot be brushed back to health. We photograph it and tell you plainly when replacement is the only honest answer.

We are replacing the AC next year. Clean now or wait?

Wait. Changing out equipment in one of these attics disturbs the plenums, the filter rack and usually the first few feet of supply, so anything we did beforehand gets undone. Have the duct scoped while the installer is quoting instead. That way the trunk and return sizing get addressed by the person opening the system, and you pay for the cleanup once.