Duct Sealing (Aerosol) in Lakeway
Sealed from inside the ducts, with a measured before-and-after leakage number.
01Lakeway — the housing record
What Lakeway actually has behind its walls.
Before anyone quotes a duct job here, this is the stock they are quoting against. It is public Census data, and it is different in every city we cover.
- Housing units
- 8,875
- Built pre-1980
- 3%
- Built 2000s
- 36%
- Built since 2010
- 35%
- Gas heat
- 26%
- Electric heat
- 63%
- Single-family
- 80%
U.S. Census Bureau, American Community Survey 5-Year Estimates (2023), tables B25034, B25040 and B25024. Percentages are rounded and describe the city, not your house.
What that means for ducts
New-build ductwork
Roughly 35% of Lakeway's homes were built since 2010. New does not mean clean: the commonest thing we pull out of a five-year-old system is the construction phase itself — drywall fines, sawdust, insulation fiber — plus builder-grade flex that was kinked or crushed on the day and has been throttling that run ever since. Photographs matter more here, not less.
That is a reading of the city’s stock, not a diagnosis of your home. Which of it applies to you is exactly what the camera settles — and why we would rather run one than quote from a postcode.
02Working in Lakeway
The part that changes from street to street.
Lakeway houses are large and they are cut into a hillside, and both facts show up in the mechanical layout rather than in the age of the duct. Most homes here are recent enough that nothing has accumulated from decades of use. What they have instead is two or three separate systems, split by floor or by wing and often tied to zone dampers and a control board, and that changes what an honest quote even looks like. A single price to clean a house means very little on this side of the lake. The number that matters is per system, and in many of these homes only one of them is doing real work. The upper zone runs hard all summer while a lower level built into the slope stays cool, so its system barely cycles, never dehumidifies, and grows things on a coil that is wet more often than it is used. Heat is electric in most of the city, so we are looking at coils and drain pans instead of burners and flues.
Lakeway Marina
- Rough Hollow ·
- Flintrock Falls ·
- The Hills ·
- Lakeway Highlands
County
Travis County
Same standard in Lakeway as everywhere else.
Source removal to the NADCA ACR standard, a written quote before anything is touched, and camera photographs of your own runs before and after. We are not going to re-argue that on every city page — it is set out once, in full, on the service page.
- Pre-seal duct leakage test with the measured result recorded
- Registers masked and the full system pressurized for aerosol sealing
- Post-seal test on the same equipment — before-and-after numbers in writing
- Accessible tears and disconnections repaired first, because sealant cannot bridge an open run
- Written report you can hand to an inspector or a utility rebate program
- From
- $1,800
- On site
- Most single-system homes in one day
- Scope
- 5 lines
Prices shown are starting estimates and may change with the condition, access, and scope we find on site. Only a written quote from an on-site visit is a price we commit to.
03Duct Sealing (Aerosol) — in this stock
Leakage in a house that should not have any.
New does not mean sealed. Production-built systems routinely have unsealed takeoffs, boots that were never mastic-sealed to the drywall, and flex that was pulled tight over a corner. It is quick, cheap work on a young house, and doing it before the first cleaning means you are not paying to clean air that is escaping anyway.
Ask us anything about this on the phone — a person answers during opening hours.
All duct sealing (aerosol) questions04Book in Lakeway
Three fields, and a person calls you back.
Tell us the ZIP and we will tell you what your system likely needs — including, sometimes, that it needs nothing yet. Nothing is charged until you have approved a written quote.
05Questions
Asked in Lakeway, answered straight.
Why do you quote per system instead of per house?
Because a house here can hold three of them and their condition is rarely the same. Quoting by the address either overcharges you for systems that are already clean or quietly leaves one out. We scope each unit, tell you which ones need work, and price only those. Two clean systems and one that needs attention is a common outcome in this city.
The lower level smells musty and it is the coolest part of the house.
That combination is common on these hillside plans and it is a runtime problem rather than a dirt problem. A system serving a level built into the slope satisfies the thermostat in minutes and shuts off, so it never runs long enough to remove moisture. Cleaning the duct will not change the humidity. Dehumidification, or a change in how that zone is controlled, will.
We have zone dampers. Do they matter for this?
Enough that we check them before anything else. A damper stuck part closed, or a bypass duct dumping supply straight back into the return, reads from inside the house exactly like a blocked branch. It is worth knowing that a control board is the cause before paying someone to brush a duct that was never obstructed in the first place.
Last reviewed: